***
Connecting the Projector:
1. Make sure the projector and your computer are turned off.
2. Open the black plastic panel on the side of the LCD projector.
3. Connect the LCD projector and computer to power, but do not turn them
on. The cables have a RED tag.
4. Connect the LCD to the computer using the parallel port cable with the
BLUE tag.
5. The parallel port goes into the LCD out to the left, on the side marked
"input", labeled computer.
6. This is a trapezoidal shaped plug with pins and 2 screws. Plug it
in and tighten the screws.
7. The other end goes in the back of the computer. Same type of plug
as described above. Do not bend pins.
***
Powering on the Projector:
1. Remove the
lens cap.
2. Ensure
that power cords and signal cables are securely connected.
3. Turn on
the main power switch to the LCD by flipping the black flip-switch on the side
of the
LCD, from "O to I".
4. Allow the projector
to warm up for 1-3 minutes.
5. Turn on
the lamp by pressing the "power/standby" button on the top panel.
6. The start
up screen will display for 20 seconds and the power/standby will light a solid
amber.
7. The
"lamp" indicator will be a solid green.
8. Turn on
the computer, laptop or video player. The LCD will detect the source
automatically.
9. Zoom
in/out using the dial on the top of the projector.
10. To focus
the display, use the dial on the lens itself.
11. To adjust
the height, push the button down low on the front of the machine.